RB-PA2 Dual Stereo RIAA Phono Amplifier

A/D Audio Specification Maximum Input Level +28 dBu Input Impedance >47kohms Input Sensitivity Range 1mV to 25mV (ref 1kHz) Maximum Output Level +28dBu Output Impedance <50ohms Output Gain Range Adjustable -58dB to -30dB via 4 multi-turn pots Crosstalk Better than -80dBu at 1kHz Frequency Response 10Hz - 15kHz (-3dB) RIAA Accuracy Within 0.5dB of RIAA curve Distortion 0.01% THD @ 1kHz, ref +8dBu output Noise -77dB (CCIR Q-Pk, 20Hz - 20kHz) Headroom 27dB for 3mV input Dynamic Range 90dB

Rear Panel Connections Analogue Inputs 4 x RCA phono sockets Analogue Outputs 4 x XLR 3pin male (balanced) (L and R) Earth Tag Grounding turret tag Mains Input Filtered IEC, switchable 110-120V or 220-240V, fused, 6W max

Audio Interfaces - Redbox - Matching Converters

Iso View	Front View	Rear View
High resolution image of iso view >>	High resolution image of front view >>	High resolution image of rear view >>

The RB-PA2 Dual Stereo RIAA Phono Amplifier.

RB-PA2 Dual Stereo RIAA Phono Amplifier

The RB-PA2 is a dual stereo RIAA equalised phono amplifier. This record player preamp amplifies the small signal from your pick up cartridge (either moving magnet or high output moving coil magnetic) and provides the necessary RIAA equalisation required for vinyl records, to match it to a line input of your mixer, or amplifier. It uses a clean RIAA response making it ideal for use with broadcast turntables and DJ decks and where vinyl records are being archived to CD for high quality transfers, or for converting albums to mp3.

It operates with phono cartridges with a nominal output of 1mV to 25mV and has been specifically tested to work with the Technics SL-1200™ and 1210™ range of turntables. Quality high specification components have been used together with low noise, fast acting operational amplifiers to produce a superbly transparent signal path. Additionally, the RB-PA2 runs without a rumble filter to produce a powerful bass response.

The RB-PA2 is a dual stereo unit to interface up to two turntables. The inputs are phono connectors with Neutrik XLR connectors for the balanced outputs, which may be wired unbalanced if required. Output gain is individually adjustable for left and right channels in the range 35dB to 65dB by using pre-set potentiometers. Frequency response is held within 0.5dB of the RIAA curve and noise is typically better than -84dB RMS A weighted at 40dB gain.

RB-PA2 Block Diagram.

See larger image >